Industrial Electrician - 3rd Shift - ref. f58494003
Milwaukee
Overview:
Industrial Electrician 3rd shift $35.67-$36.42/hour
Responsibilities:
Essential Duties and Responsibilities:- Work with prints and drawings, and analyze circuitry problems.
- Disconnect, replace, and reconnect electric motors from fractional HP up to 50 HP.
- Install conduit for installing and replacing equipment, may involve working on ladders and lift platforms.
- Redesign and engineer changes in machinery.
- Check, analyze, and repair hydraulic and pneumatic systems.
- Hazardous Duty work
- Preventive maintenance work, and maintaining the plant facility
Qualifications:
Minimum Qualifications:- Four (4) years of industrial electrical maintenance experience.
- Knowledge of safe electrical practices for grounding, locking out, de-energizing, testing and disabling electrical circuits to prevent injury to self and other persons.
- Knowledge of National Electric Code.
- Ability to climb in overhead structures, to work beneath machines and in close quarters performing analysis and repair work.
- A high degree of precision working with minimum tolerances and a high degree of attention and care to prevent injury to others when responsible for flow of electrical power.
- Will be required to take an Electrician test.
Preferreds:
- Approved State Indentured Journeyman Electrician’s Apprenticeship and active card holder
- Ability to use advanced shop mathematics; work with complicated advanced drawings, specifications, and formulas.
Snap-on is an Equal Opportunity Employer, Minority/Female/Disabled/Veteran
#Snaponhiring
Milwaukee
Description:
Tradesmen International is immediately hiring skilled and motivated Apprentice Industrial Electricians for projects located in and around Milwaukee, WI. This is a full time opportunity working 50-60 hours per week. The pay range...
Harley-DavidsonMenomonee Falls, 14 mi from Milwaukee
facility to determine mechanical or electrical failure
• Responsible for complex troubleshooting of industrial electrical and electronic systems on CNCs, Robotics, and PLCs
• Both aluminum and steel machining utilizing CNC controllers, servo motors and HMIs...
Milwaukee
conduit
• Blueprint reading
• Read a tape measure all the way up to 1/16th of an inch
• Wire installation
• Other tasks as assigned
Requirements:
• 3+ Years of Commercial or Industrial Electrical work
• Proficiency in blueprint reading
• Ability to read...